Free energy generator made of…

Free energy generator made of…

Free energy generator made of…

It can now be demonstrated that the LED does not light directly from the battery. I offer 2 options: 1 - short with fun music, 2 - longer with explanations To tell that even though the battery is AA, but unusual, not 1.5 volts, but lithium 3.6. First you need to clarify that a standard "finger" AA battery produces 1.5 volts. Next, we need a piece of wire 30 centimeters. 11. Not every battery can do this. Usachev, A. I took an ordinary copper cable 1.5 mm2 and freed one core from insulation: Now is the time to “be smart”, tell about the oscillatory circuit, about the world anti-Ether conspiracy, etc. Now it remains to bend the legs of the LED, observing the polarity and calculating the distance from the " " contact to the LED by the size of a carbon tablet: It is possible not to cut if it is difficult, but mechanically the final construction will be somewhat more difficult: 4. From the resulting piece of copper wire we make a coil of any size. 5. It will not make a trick of the impression: one half of the audience will simply say that what the heck, well, he took a one and a half volt diode, https://jiji.co.tz/cars/toyota-mr2-spyder that's business. 6. © A. And now the most important thing is to tell the essence. It looked impressive. Hello, inspired by a recent post about "perpetual motion", I remembered one video on the Internet, where one craftsman "set fire" to an LED from AA batteries using a coil of several turns and activated carbon tablets. 2. 1. So that even thoughts about the “miracle” do not remain, because children must definitely develop critical thinking. I wound it right over the battery: 8. To do this, demonstrate the inscription on it, as well as the luminosity of the LED without any tablets, magnets and coils: I used the first option. So I decided to make a homemade product in 3 minutes. Entertaining the younger generation

Children are a perpetual motion machine, a jumper, a runner, a pusher, a jumper, a grabber, and also a tight hug and a kisser 9. Although https://tonaton.ug/s_142-tiling-services the solution is quite easy to read.

Free energy generator made of activated carbon, magnet and coil. Pinegin 7. Naturally, there was no clue to the trick. Video versions: Then we change the tablet to a magnet. Demonstrating the "wonderful" glow of the LED: Be sure to show special joy if an attentive child points to point 3 in which we demonstrated the impossibility of the LED to glow directly from the battery. Good luck to everyone! One
from the ends of the coil we bend and fasten with electrical tape (necessarily blue) to the bare part of the battery: 3. Next, we take an AA battery and cut off the film from the top for convenience. We put in a charcoal tablet, which closes the circuit. To power the LED, you need about a volt more. I won't advise here, I think you can fantasize a lot: The second half, which is aware of the impossibility of one and a half volt white LEDs, will definitely not be led to the resonances of the world This can be demonstrated using an adjustable voltage source: There are at least 2 options here: a dead battery and a faulty LED. Naturally, because this is an LED, you need to demonstrate it in both polarities, explaining the reason:
Focus demonstration: Everything is ready for the demonstration of the "miracle". Thank you for your attention. 10.

No Comments

Post a Reply

error: Content is protected !!